LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine - 5.2L 32V Ti-VCT) >> Removal And Installation >> Engine Mount LH >> Removal

Engine Mount LH: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
  2. Disconnect the battery ground and positive cables. Refer to: Battery Disconnect and Connect .
    1. Detach the wiring harness retainer.
    2. Remove and discard the nuts. Remove the strut tower cross brace.
    GFD286372Courtesy of FORD MOTOR COMPANY
  4. Remove the following items:

    1. Refer to: Air Cleaner Outlet Pipe .
    2. Refer to: Air Cleaner .

  5. Remove the LH engine mount nut.
    GFD286373Courtesy of FORD MOTOR COMPANY
  6. Remove the RH engine mount nut.
    GFD286374Courtesy of FORD MOTOR COMPANY
  7. Remove the bolts and the underbody shield.
    GFD286375Courtesy of FORD MOTOR COMPANY
  8. Remove the bolts and the underbody shield.
    GFD286376Courtesy of FORD MOTOR COMPANY
  9. Remove the bolts and disconnect the oil cooler hoses.
    GFD286377Courtesy of FORD MOTOR COMPANY
  10. NOTE: Do not position the legs of the Engine Support Bar on the fenders. Instead, the legs should be positioned on the body structure. Failure to follow these instructions may result in body damage.

    Install the special tools and raise the engine 50 mm (2 inch). Use Special Service Tool: 303-F072 Support Bar, Engine, 303-050 (T70P-6000) Lifting Bracket, Engine.

    GFD286328Courtesy of FORD MOTOR COMPANY
  11. Remove the bolts and the engine mount.
GFD286378Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals