LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (Transfer Case - 2.0L ECOBOOST (184KW/250PS) - Mi4) >> Removal And Installation >> Transfer Case Rear Seal >> Removal

Transfer Case Rear Seal: Removal

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the PTU (Power Transfer Unit). Refer to: Transfer Case .
  2. Using the special tool, remove and discard the pinion flange nut. Use Special Service Tool: 205-126 (T78P-4851-A) Holding Fixture, Drive Pinion Flange.
    GFD281819Courtesy of FORD MOTOR COMPANY
    1. Mark the pinion flange and the transfer case for reassembly.
    2. Using the puller, remove the pinion flange. Use the General Equipment: Puller
    GFD281820Courtesy of FORD MOTOR COMPANY
  4. Remove and discard the transfer case rear seal.
GFD281821Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals