Transmission Fluid Warmer: Installation
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Install the transmission fluid warmer and the bolts.
Torque: 18 lb.ft (25 Nm)
- Inspect and lubricate the band seals and backing rings.
- Backing ring (7J324)
- Band seal (7D285)
Material: Motorcraft® MERCON® LV Automatic Transmission Fluid / XT-10-QLVC (WSS-M2C938-A) (MERCON® LV,)
- Connect the transmission fluid cooler tubes to the transmission fluid warmer and install the bolts.
Torque: 89 lb.in (10 Nm)
- Connect the coolant hoses to the transmission fluid warmer and position the clamps and remove the tool. Use the General Equipment: Hose Clamp(s)
- Install the battery tray. Refer to: Battery Tray .
- Check the transmission fluid level. Refer to: Transmission Fluid Level Check .