LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (ENGINE COOLING - 3.5L DURATEC (212kW/278PS)) >> Removal And Installation >> Cooling Module >> Installation

Cooling Module: Installation

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
  2. NOTE: Only use the specified material to lubricate the seals.

    Install new condenser fitting O-ring seals.

    Material: Motorcraft® PAG Refrigerant Compressor Oil / YN-12-D (WSH-M1C231-B)

  3. Fill and bleed the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .
  4. Check and fill the transmission fluid as necessary. Refer to: Transmission Fluid Level Check .
scientia non olet · About LEMON Manuals