LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Steering Wheel And Column Electrical Components) >> Diagnosis And Testing >> Steering Wheel and Column Electrical Components >> Pinpoint Tests >> Pinpoint Test G : B135C:11, B135C:15 >> Notes

Pinpoint Test G : B135C:11, B135C:15: Notes

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Adjustable Steering Column for schematic and connector information.

Normal Operation and Fault Conditions 

When steering wheel heat is requested and the engine is running, the HSWM applies voltage and ground to the steering wheel heating element (integral to the steering wheel). The steering wheel heating element draws between 1 and 10 amps of current depending on steering wheel temperature. The HSWM uses a sensor in the steering wheel (integral to the steering wheel) to maintain the heated steering wheel temperature. The HSWM is designed to remain on, heating the steering wheel and maintaining temperature until switched OFF using the FDIM or the ignition is turned OFF.

HSWM DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
B135C:11 Heater Element: Circuit Short to Ground Sets when the heated steering wheel is commanded on and the HSWM senses current greater than 10 amps from the steering wheel heating element output circuit, indicating a short to ground or when the steering wheel heating element output Field Effect Transistor (FET) in the HSWM has a thermal failure. When this fault sets, the steering wheel heating element output is disabled until the ignition is cycled.
B135C:15 Heater Element: Circuit Short to Battery or Open Sets when the heated steering wheel is commanded on and the module senses current less than 1 amp from the steering wheel heating element output circuit. This indicates a short to voltage, an open circuit or an open in the heating element. When this fault sets, the steering wheel heating element output is disabled until the ignition is cycled.

Possible Causes 

scientia non olet · About LEMON Manuals