LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2018 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Steering Wheel And Column Electrical Components) >> Diagnosis And Testing >> Steering Wheel and Column Electrical Components >> Pinpoint Tests >> Pinpoint Test E : B11D9:17 >> Notes

Pinpoint Test E : B11D9:17: Notes

WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Power Distribution for schematic and connector information.

Normal Operation and Fault Conditions 

The SCCM continuously monitors input voltage for correct operation. If voltage outside of defined limits is detected by the SCCM, the applicable DTC sets. DTC B11D9:17 can set if the vehicle has been recently jump started or the vehicle battery has been recently charged.

SCCM DTC Fault Trigger Conditions 

DTC Description Fault Trigger Conditions
B11D9:17 Vehicle Battery: Circuit Above Threshold Sets in continuous memory if the SCCM detects battery voltage above 19 volts on the battery voltage supply circuit.

Possible Causes 

scientia non olet · About LEMON Manuals