Pinpoint Test A : All Windshield Wiper Modes Are Inoperative From One Or Both Windshield Wiper Motors: Notes
WARNING: This page is about a different car, the 2018 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
Refer to Wipers and Washers for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Wipers and Washers - System Operation and Component Description .
BCM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B130F:12 | Run Accessory Control: Circuit Short To Battery | Sets when the BCM detects a short to voltage from the wiper relay control circuit. |
| B130F:14 | Run Accessory Control: Circuit Short To Ground or Open | Sets when the BCM detects an open from the wiper relay control circuit. |
Possible Sources
- Fuse
- Wiring, terminals or connectors
- BJB
- Windshield wiper motor
- SCCM
- BCM
Visual Inspection and Diagnostic Pre-checks
- Inspect BJB fuses 80 (25A) and 75 (25A) and make sure they are OK.