Fuel Rail Pressure (FRP) Sensor: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the FRP sensor and tighten in 5 stages:
- Stage 1:
Torque
: 53 lb.in (6 Nm)
- Stage 2:
Angle
: 5°
- Stage 3: Loosen:: 90°
- Stage 4:
Torque
: 53 lb.in (6 Nm)
- Stage 5:
Angle
: 21°
- Stage 1:
- Install the FRP sensor electrical connector.
- Connect the battery ground cable. Refer to: Battery Disconnect and Connect .