Pinpoint Test A : Engine Does Not Crank: Notes
WARNING: This page is about a different variant/trim than selected.
Refer to Starting System for schematic and connector information.
Refer to Turn Signal/Stop/Hazard Lamps for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Starting System - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P06E9 | Engine Starter Performance | The PCM sets this DTC when no engine rotation is detected during a crank event. |
| P0833:23 | Clutch Pedal Switch B Circuit: Signal Stuck Low | This DTC sets when the BCM detects a short to ground on the clutch bottom of travel circuit during an on-demand self test. |
Possible Sources
- Battery
- Battery cables
- Starter motor
- BJB starter relay
- CPP switch
Visual Inspection and Diagnostic Pre-checks
- Inspect high current BJB connections.
- Inspect BJB fuse 13 (30A).
- Inspect BCM fuse 78 (5A).
- Inspect the Integrated Keyhead Transmitter (IKT).