Input Shaft Seal: Installation

WARNING: This page is about a different variant/trim than selected.

1. NOTE: Use adhesive tape to cover the input shaft splines to prevent damage to the input shaft seal.
  
  Apply tape to the splines to protect the seal. Use the General Equipment: Adhesive Tape
2. NOTE: Make sure that a new component is installed.
  
  Position a new seal on the input shaft in the clutch housing.
3. Using the special tool, install the seal. Use Special Service Tool: 308-847 Installer, Inputshaft Seal.
4. Remove and discard the tape.
Courtesy of FORD MOTOR COMPANY
Install the clutch slave cylinder and tighten the bolts.
Torque: 89 lb.in (10 Nm)

Courtesy of FORD MOTOR COMPANY
Install the transmission. Refer to: Transmission .