Pinpoint Test D : P2535: Notes
Normal Operation and Fault Conditions
When the ignition is turned to the START position the PCM receives a voltage signal on the crank detect circuit. The PCM supplies voltage and ground to the starter relay coil when the required inputs have been received.
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P2535 | Ignition Switch Run/Start Position Circuit High | This DTC sets when the PCM detects a short to voltage on the crank detect circuit while the engine is running. |
Possible Sources
- BJB
- Ignition switch
- PCM
- Wiring, terminals or connectors