Pinpoint Test S : The Rear Video Is Inoperative: Notes
Refer to Wiring Diagrams Cell 131 for schematic and connector information.
Normal Operation and Fault Conditions
See Image Display. Refer to: Parking Aid - System Operation and Component Description .
Image Processing Module - B (IPM-B) DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B115E:08 | Camera Module: Bus Signal/Message Failure | A continuous memory and on-demand DTC that sets in the Image Processing Module - B (IPM-B) when there is a LIN communication fault from the video camera. |
APIM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| C1001:01 | Vision System Camera: General Electrical Failure | A continuous memory and on-demand DTC that sets in the APIM when no video signal is detected from the video camera when the vehicle is in REVERSE. |
Possible Sources
- Wiring, terminals or connectors
- Video camera
- FDIM concern
- APIM concern
- BCM
- Image Processing Module - B (IPM-B) (vehicles built on or before November 17, 2013)
Visual Inspection and Diagnostic Pre-checks
Verify the manual zoom feature is enabled.