Engine Cooling System - 2.5L DURATEC (125KW/170PS)

• Specifications
  • Specifications
• Description And Operation
  • Engine Cooling - System Operation and Component Description
    • System Operation
      • Notes
      • Fail Safe Cooling
    • Component Description
      • Transmission Fluid Heater Coolant Control Valve
      • Transmission Fluid Cooler Coolant Control Valve
  • Engine Cooling - Component Location
• Diagnosis And Testing
  • Engine Cooling
    • Notes
    • PCM DTC Chart
    • Inspection and Verification
    • Symptom Chart
    • Pinpoint Tests
      • PINPOINT TEST A : Loss of Coolant
        • Notes
        • Pinpoint Test A : Pinpoint Test
      • PINPOINT TEST B : The Engine Overheats
        • Notes
        • Pinpoint Test B : Pinpoint Test
      • PINPOINT TEST C : The Engine Does Not Reach Normal Operating Temperature
        • Notes
        • Pinpoint Test C : Pinpoint Test
    • Component Tests
      • Cooling System Pressure Test
      • Thermostat
      • Radiator Leak Test, Removed From Vehicle
• General Procedures
  • Cooling System Draining, Vacuum Filling and Bleeding
  • Cooling System Draining, Filling and Bleeding
  • Radiator Lower Mounting Repair
  • Radiator Upper Mounting Repair
• Removal And Installation
  • Block Heater
    • Notes
    • Removal
    • Installation
  • Coolant Pump
    • Notes
    • Removal
    • Installation
  • Cooling Fan Motor and Shroud
    • Notes
    • Removal
    • Installation
  • Radiator
    • Notes
    • Removal
    • Installation
  • Thermostat
    • Notes
    • Removal
    • Installation