Pinpoint Test I : B1B36:96, B1B38:96, B1B40:96, B1B42:96: Notes
Refer to Parking Aid for schematic and connector information.
Normal Operation and Fault Conditions
When the ignition is on, the selector lever is in drive and vehicle speed is less than 12 kmh (7.5 mph) the PAM monitors the attenuation time of each front parking aid sensor signal.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B1B36:96 | Right Front Outer Sensor: Component Internal Failure | A continuous and on-demand DTC that sets when the right front outer parking aid sensor has internally failed or has an incorrect attenuation time. |
| B1B38:96 | Right Front Inner Sensor: Component Internal Failure | A continuous and on-demand DTC that sets when the right front inner parking aid sensor has internally failed or has an incorrect attenuation time. |
| B1B40:96 | Left Front Outer Sensor: Component Internal Failure | A continuous and on-demand DTC that sets when the left front outer parking aid sensor has internally failed or has an incorrect attenuation time. |
| B1B42:96 | Left Front Inner Sensor: Component Internal Failure | A continuous and on-demand DTC that sets when the left front inner parking aid sensor has internally failed or has an incorrect attenuation time. |
Possible Sources
- Front parking aid sensor
- PAM
NOTE:
Before disconnecting the PAM or any of the parking aid sensors, verify the connectors are properly seated and latched.