Pinpoint Test Ax : The Ignition-Engine On Warning Chime Is Inoperative
WARNING: This page is about a different car, the 2015 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- AX1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Unbuckle the driver safety belt.
- Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.
Does the safety belt warning chime operate for approximately 6 seconds?
Yes GO to AX2 No Refer to IPC Hardware Testing . - AX2 CHECK THE DOOR AJAR INDICATION
- Open the driver door.
- Observe the door ajar message center warning indicator.
Does the door ajar message center warning indicator turn on with the driver door ajar?
Yes GO to AX3 No GO to Pinpoint Test AC - AX3 CHECK THE PRNDL OPERATION
- Shift the transmission range selector through the ranges while observing the PRNDL indication.
Does the PRNDL indication match the selected transmission range?
Yes GO to AX4 No GO to Pinpoint Test O - AX4 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to DTC Chart: IPC No GO to AX5 - AX5 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: COMMUNICATIONS NETWORK - 2.0L DURATEC - HYBRID (96KW 130PS) No Refer to ENGINE CONTROLS - INTRODUCTION (HYBRID) . DIAGNOSE all SOBDMC Diagnostic Trouble Codes (DTCs).