LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2016 >> Edge SE, AWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Seats >> Seating System - Rear >> Diagnosis And Testing >> Rear Seats >> Pinpoint Tests >> Pinpoint Test G : The LH (Left-Hand) Rear Power Fold Seat Is Inoperative >> Pinpoint Test G : The LH (Left-Hand) Rear Power Fold Seat Is Inoperative

Pinpoint Test G : The LH (Left-Hand) Rear Power Fold Seat Is Inoperative

  1. G1 CHECK THE SECOND ROW REAR SEAT MOTOR GROUND

    • Ignition OFF.
    • Disconnect LH Second Row Rear Seat Motor C3345 .
    • Ignition ON.
    • Measure:
      Positive Lead Measurement / Action Negative Lead
      C3345-2
      GFD17316Courtesy of FORD MOTOR COMPANY
      Ground

    Is the resistance less than 3 ohms? 

    Yes  GO to  G2
    No  REPAIR the circuit.
  2. G2 CHECK FOR VOLTAGE TO THE SECOND ROW REAR SEAT MOTOR

    • Ignition ON.
    • While pressing and holding the LH second row seat control switch, measure:
      Positive Lead Measurement / Action Negative Lead
      C3345-1
      GFD17316Courtesy of FORD MOTOR COMPANY
      C3345-2

    Is the voltage greater than 11 volts while the second row seat control switch is pressed? 

    Yes  INSTALL a new LH second row seat motor. REFER to: Power Fold Seat Motor .
    No  GO to  G3
  3. G3 CHECK THE SECOND ROW REAR SEAT MOTOR CIRCUIT FOR AN OPEN

    • Ignition OFF.
    • Disconnect Second Row Seat Control Switch C4512 .
    • Measure:
      Positive Lead Measurement / Action Negative Lead
      C3345-1
      GFD17316Courtesy of FORD MOTOR COMPANY
      C4512-1

    Is the resistance less than 3 ohms? 

    Yes  INSTALL a new second row seat control switch. REFER to: Power Fold Seat Control Switch .
    No  REPAIR the circuit.