LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2015 >> Transit Connect Titanium >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation, Message Center And Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test BA : U3006:16 >> Pinpoint Test BA : U3006:16

Pinpoint Test BA : U3006:16

  1. BA1 CARRY OUT THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

    • Ignition ON.
    • Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs).
    • Wait 10 seconds.
    • Using a diagnostic scan tool, perform the IPC self-test.

    Is DTC U3006:16 still present? 

    Yes  GO to  BA2
    No  The system is operating correctly at this time. The DTC may have been set due to a previous low battery voltage condition.

  2. BA2 CHECK FOR CHARGING SYSTEM DIAGNOSTIC TROUBLE CODES (DTCS) IN THE BCM (BODY CONTROL MODULE)

    • Using a diagnostic scan tool, perform the BCM on-demand self-test.

    Are any charging system Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Body Control Module (BCM)
    No  GO to  BA3

  3. BA3 CHECK THE BATTERY CONDITION AND STATE OF CHARGE

    • Check the battery condition and verify the battery is fully charged.

    Is the battery OK and fully charged? 

    Yes  GO to  BA4
    No  CHARGE or INSTALL a new battery. REFER to: Battery - 1.6L EcoBoost (132kW/180PS) - Sigma REFER to: Battery - 2.5L Duratec (125kW/170PS)

  4. BA4 CHECK THE IPC (INSTRUMENT PANEL CLUSTER) VOLTAGE SUPPLY AT THE IPC (INSTRUMENT PANEL CLUSTER)

    • Ignition OFF.
    • Disconnect IPC C220 .
    • Ignition ON.
    • Measure:
      Positive Lead Measurement / Action Negative Lead
      C220-3
      GFD38392Courtesy of FORD MOTOR COMPANY
      		 Ground

    Is the voltage greater than 11 volts? 

    Yes  GO to  BA5
    No  REPAIR the circuit for high resistance.

  5. BA5 CHECK THE IPC (INSTRUMENT PANEL CLUSTER) GROUND

    • Measure:
      Positive Lead Measurement / Action Negative Lead
      C220-3
      GFD38392Courtesy of FORD MOTOR COMPANY
      		 C220-10

    Is the voltage greater than 11 volts? 

    Yes  GO to  BA6
    No  REPAIR the circuit for high resistance.

  6. BA6 CHECK FOR CORRECT IPC (INSTRUMENT PANEL CLUSTER) OPERATION

    • Ignition OFF.
    • Disconnect and inspect the IPC connector.
    • Repair:
      • corrosion (install new connector or terminals - clean module pins)
      • damaged or bent pins - install new terminals/pins
      • pushed-out pins - install new pins as necessary
    • Reconnect the IPC connector. Make sure it seats and latches correctly.
    • Operate the system and determine if the concern is still present.

    Is the concern still present? 

    Yes  CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, Refer to IPC Hardware Testing .
    No  The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.
scientia non olet · About LEMON Manuals