Timing Adjustment

WARNING: This page is about a different car, the 2015 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Adjustment

NOTE: Any time a roof opening panel motor is removed, the cables/mechanisms can experience free-play movement. It is important that the cables do not move. They are timed to be parallel with each other. If one or both are moved in either direction, the Timing Adjustment must be performed.

NOTE: The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel system or when the roof opening panel motor, glass, assembly, or air deflector has been removed or replaced for any reason.

1.

WARNING: Before beginning any service procedure in this article, refer to Health and Safety Precautions . Failure to follow this instruction may result in serious personal injury.

Refer to: Health and Safety Precautions .

2.

NOTE: The roof opening panel should be as close to the vent position as possible before adjusting the timing of the cables.

Place the roof opening panel in the vent position.

3.

Pull both cables forward to the vent position to correct any offset of the cable timing.

4.

NOTE: When positioning the roof opening panel motor, it may be necessary to turn the roof opening panel motor slightly to engage the drive splines.

Refer to: Roof Opening Panel Motor .

5.

Refer to: Roof Opening Panel Alignment .

6.

Refer to: Power Roof Opening Panel Initialization .