Pinpoint Test Am: The Check Fuel Fill Inlet Message Is Always Displayed

• Ignition ON.
• Close all doors the hood and luggage compartment lid.
• Clear all message center warnings by pressing the OK button for each warning present.
• Monitor the door ajar message center warning indicator.
• Open the driver door.
• Clear the message center popup warning.
• Monitor the door ajar message center warning indicator.

Is the door ajar message center warning indicator off with the door closed, and on with the door open? 

• Yes  :
• No:  INSTALL a new IPC.

  REFER to: INSTRUMENT PANEL CLUSTER (IPC) .

• Using a diagnostic scan tool, perform the IPC self-test.

Are any Diagnostic Trouble Codes (DTCs) recorded? 

• Yes:  REFER to DTC CHART: IPC .
• No:  GO to AM3 

• Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).

Are any Diagnostic Trouble Codes (DTCs) recorded? 

• Yes:  REFER to: COMMUNICATIONS NETWORK - 2.0L DURATEC - HYBRID (96KW/130PS) .
• No:  If the check fuel fill inlet message is never on, the system is operating correctly at this time. There are currently no vehicle concerns present that require the check fuel fill inlet message display.

  If the check fuel fill inlet message is always on, DIAGNOSE all PCM Diagnostic Trouble Codes (DTCs).

  REFER to: ELECTRONIC ENGINE CONTROLS .

  Refer to INTRODUCTION - HYBRID .