Pinpoint Test AP: The Active Park Assist/Parking Aid Chime Is Inoperative

AP1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Unbuckle the driver safety belt.
- Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.
Does the safety belt warning chime operate for approximately 6 seconds?
- Yes: GO to AP2
- No: INSTALL a new IPC.
  REFER to: INSTRUMENT PANEL CLUSTER (IPC) .
AP2 VERIFY THE CHIMES FUNCTION THROUGH THE AUDIO SPEAKERS
- Ignition OFF.
- Ignition ON.
- Monitor the location of the safety belt warning chime (front/rear audio speakers or IPC) when the ignition is transitioned from OFF to RUN.
Does the chime sound through the audio speakers?
- Yes: GO to AP4
- No: GO to AP3
AP3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
- Yes: REFER to: COMMUNICATIONS NETWORK - 2.0L DURATEC - HYBRID (96KW/130PS) .
- No: GO to AP4
AP4 PERFORM THE PARKING AID MODULE (PAM) SELF-TEST
- Using a diagnostic scan tool, perform the Parking Aid Module (PAM) self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
- Yes: REFER to: PARKING AID .
  Vehicles With: Active Park Assist REFER to: PARKING AID .
- No: GO to AP5
AP5 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
- Yes: REFER to DTC CHART: IPC .
- No: DIAGNOSE the audible parking aid.
  REFER to: PARKING AID .
  
  Vehicles With: Active Park Assist, REFER to: PARKING AID .