Pinpoint Test D: B10D7:05

NOTE: This pinpoint test may require a second IA key. If only one key is available, a second IA key must be obtained.

D1 REVIEW THE RFA MODULE DTCs FROM THE ON-DEMAND SELF-TEST
- Review the RFA module DTCs from the on-demand self-test.
Are any other RFA module DTCs present?
- Yes : REFER to the RFA MODULE DTC CHART .
- No : GO to D2 .
D2 CHECK THE IA KEYS
- Verify the correct IA keys are used with the vehicle.
Are the correct keys used?
- Yes : ATTEMPT to program the key again. REFER to KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT .
  If the key programming fails, GO to D3 .
- No : OBTAIN the correct key(s) for the vehicle. PROGRAM the new key(s). REFER to KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT .
D3 CHECK BOTH IA KEYS
NOTE: At least 2 IA keys must be present to carry out this pinpoint test step.
- Program both IA keys. Refer to KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT .
- After both IA keys have been programmed, attempt to start the vehicle with each IA key (one key inside the vehicle at a time).
Does the vehicle start with only one IA key?
- Yes : REPLACE the IA key that did not program. PROGRAM the new IA key. REFER to KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT .
- No : If the vehicle started with both IA keys, the vehicle is operating correctly. The concern was cause by an unprogrammed IA key.
  If neither IA key starts the vehicle, INSTALL a new backup transceiver. REFER to BACKUP TRANSCEIVER . PROGRAM the IA keys. REFER to KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT .