The Luggage Compartment Lid Passive Entry Feature Is Inoperative

X1 CHECK THE LUGGAGE COMPARTMENT LID LATCH RELEASE OPERATION
- Ignition ON.
- Unlock the doors using the door lock control switch.
- Press the luggage compartment lid release button located on the rear of the vehicle.
Does the luggage compartment lid latch release?
- Yes : GO to X2
- No : GO to PINPOINT TEST N
X2 CHECK THE RKE (REMOTE KEYLESS ENTRY) OPERATION
- Close the luggage compartment lid.
- Press the luggage compartment lid release button twice on a key.
Does the luggage compartment lid latch release?
- Yes : GO to X3
- No : GO to PINPOINT TEST T

X3 CHECK THE KEYLESS ENTRY REAR ANTENNA

Ignition OFF.
Disconnect Keyless Entry Rear Antenna C4082 .

Measure:

Positive Lead	Measurement/Action	Negative Lead
C4082, pin 1, component side		C4082, pin 2, component side

Is the resistance between 1 and 3 ohms?

Yes : GO to X4
No : INSTALL a new keyless entry rear antenna.
REFER to: KEYLESS ENTRY REAR ANTENNA .

X4 CHECK THE KEYLESS ENTRY REAR ANTENNA CIRCUITS FOR A SHORT TO VOLTAGE

Disconnect BCM C2280E .
Ignition ON.

Measure:

Positive Lead	Measurement/Action	Negative Lead
C2280E-16		Ground
C2280E-15		Ground

Is any voltage present?

Yes : REPAIR the affected circuit.
No : GO to X5

X5 CHECK THE KEYLESS ENTRY REAR ANTENNA CIRCUITS FOR A SHORT TO GROUND

Ignition OFF.

Measure:

Positive Lead	Measurement/Action	Negative Lead
C2280E-16		Ground
C2280E-15		Ground

Are the resistances greater than 10, 000 ohms?

Yes : GO to X6
No : REPAIR the affected circuit.

X6 CHECK THE KEYLESS ENTRY REAR ANTENNA CIRCUITS FOR AN OPEN

Measure:

Positive Lead	Measurement/Action	Negative Lead
C2280E-16		C4082-1
C2280E-15		C4082-2

Are the resistances less than 3 ohms?

Yes : GO to X7
No : REPAIR the affected circuit.

X7 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
- Disconnect and inspect all the BCM connectors.
- Repair:
  - corrosion (install new connectors or terminals - clean module pins)
  - damaged or bent pins - install new terminals pins
  - pushed-out pins - install new pins as necessary
- Reconnect the BCM connectors and make sure they seat and latch correctly.
- Operate the system and determine if the concern is still present.
Is the concern still present?
- Yes : CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new BCM .
  REFER to: BODY CONTROL MODULE (BCM) .
- No : The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.