DTC Charts
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: DIAGNOSTIC METHODS .
HUD DTC CHART
| DTC | Description | Action |
|---|---|---|
| U0104:00 | Lost Communication With Cruise Control Module: No Sub Type Information | GO to PINPOINT TEST C |
| U0146:00 | Lost Communication With Gateway "A": No Sub Type Information | GO to PINPOINT TEST D |
| U0405:68 | Invalid Data Received From Cruise Control Module: Event Information | This DTC sets when the HUD module receives invalid network data from the CCM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U0447:68 | Invalid Data Received From Gateway "A": Event Information | This DTC sets when the HUD module receives invalid network data from the GWM . RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U210A:16 | Temperature Sensor: Circuit Voltage Below Threshold | GO to PINPOINT TEST F |
| U210A:17 | Temperature Sensor: Circuit Voltage Above Threshold | GO to PINPOINT TEST F |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test. If DTC
U3000:41 is retrieved again, INSTALL a new HUD
module. REFER to: HEAD UP DISPLAY (HUD) MODULE . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to PINPOINT TEST G |
| U3003:1C | Battery Voltage: Circuit Voltage Out of Range | GO to PINPOINT TEST H |
CRUISE CONTROL MODULE (C-CM) DTC CHART
| DTC | Description | Action |
|---|---|---|
| C1132:4B | Head Up Display: Over Temperature | GO to PINPOINT TEST E |