LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Fusion Titanium, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Collision Avoidance (Except Hybrid) >> Diagnosis and Testing >> Collision Warning System >> Pinpoint Tests >> PINPOINT TEST F: U210A:16 Or U210A:17 >> U210A:16 Or U210A:17

U210A:16 Or U210A:17

  1. F1 CHECK FOR HUD (HEAD UP DISPLAY) MODULE DIAGNOSTIC TROUBLE CODES (DTCS) 
    • Engine OFF.
    • Ignition ON.
    • Using a diagnostic scan tool, clear the HUD  module Continuous Memory Diagnostic Trouble Codes (CMDTCs).
    • Retrieve Continuous Memory Diagnostic Trouble Codes (CMDTCs).

    Is DTC U210A:16 or U210A:17 recorded? 

    • Yes  : GO to F2 
    • No  : The system is operating normally at this time. The DTC  may have been set previously due to an internal intermittent fault with the temperature sensor circuit.
  2. F2 CHECK FOR CORRECT HUD (HEAD UP DISPLAY) OPERATION 
    • Ignition OFF.
    • Disconnect and inspect all HUD  module connectors.
    • Repair:
      • corrosion (install new connector or terminals - clean module pins)
      • damaged or bent pins - install new terminals/pins
      • pushed-out pins - install new pins as necessary
    • Reconnect the HUD  module connectors. Make sure they seat and latch correctly.
    • Operate the system and determine if the concern is still present.

    Is the concern still present? 

    • Yes  : CHECK OASIS  for any applicable Technical Service Bulletins (TSBs). If a TSB  exists for this concern, DISCONTINUE this test and FOLLOW TSB  instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new HUD  module.

      REFER to: HEAD UP DISPLAY (HUD) MODULE  .

    • No  : The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.
scientia non olet · About LEMON Manuals