LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2013 >> Fusion Titanium, FWD >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center, And Warning Chimes (Except Hybrid) >> Removal and Installation >> Instrument Panel Cluster (IPC) >> Removal

Instrument Panel Cluster (IPC): Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. WARNING: Before beginning any service procedure, refer to Safety Warnings in GENERAL INFORMATION -- FUSION . Failure to follow this instruction may result in serious personal injury.

    Refer to: HEALTH AND SAFETY PRECAUTIONS .

  2. NOTE: If installing a new IPC  , it is necessary to upload the module configuration information to the scan tool prior to removing the IPC  . This information must be downloaded into the new IPC  after installation.

    Upload the module configuration information from the IPC  into the scan tool by following the scan tool on screen instructions. Record the odometer value from the original IPC  . If the odometer value cannot be obtained from the IPC  (display failure), perform the diagnostic routine. If the value cannot be obtained after the diagnostic routine, the customer should supply the approximate odometer value.

  3. G08638516
  4. G08638517
  5. G08638518
  6. G08638519
  7. Torque  : 2.5 Nm
    G08638520
  8. Torque  : 2.5 Nm
    G08638521
  9. Torque  : 3 Nm
    G08638522
scientia non olet · About LEMON Manuals