IPC Prove-Out
The IPC and other vehicle modules carry out a display prove-out to verify that all module controlled informational and warning indicators and monitored systems are functioning correctly within the IPC. When the ignition is transitioned to the ON state with the engine off, the indicators illuminate to prove-out according to the following table:
| Indicator | Indicator Type | Prove-Out Duration |
|---|---|---|
| ABS | Warning | 3 seconds |
| Air bag | Warning | 6 seconds |
| Anti-theft indicator | Informational | 3 seconds |
| Brake | Warning | 3 seconds |
| Charge | Informational | Engine start up |
| Cruise control | Informational | 3 seconds |
| Door ajar | Informational | No prove-out |
| Engine over-temperature | Warning | 3 seconds |
| High beam | Informational | No prove-out |
| Low engine oil pressure | Warning | Engine start up |
| Low fuel | Informational | 3 seconds |
| Malfunction Indicator Lamp (MIL) | Warning | Engine start up |
| Overdrive off | Informational | No prove-out |
| RH/LH turn signals | Informational | No prove-out |
| Safety belt | Warning | 60 seconds if the safety belt is unbuckled, turns off when the safety belt is buckled (controlled by the Restraints Control Module (RCM)) |
| Tire Pressure Monitoring System (TPMS) | Warning | 3 seconds |
| Traction control | Informational | 3 seconds (controlled by the ABS module) |