Bumper - Front, Lower

WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For information on Ford Color Coded Illustrations refer to COLOR-CODING - FORD .

Remove the front bumper cover. For additional information, refer to BUMPER COVER - FRONT .
Remove the 2 nuts from the power steering cooler pipe-to-lower front bumper.
- To install, tighten to 7 Nm (62 lb-in).
  
  Fig 1: Locating Power Steering Cooler Pipe-To-Lower Front Bumper Mounting Nuts
  Courtesy of FORD MOTOR CO.
Remove the 6 bumper-to-radiator support nuts (3 each side) and remove the lower front bumper.
- To install, tighten to 25 Nm (18 lb-ft).
  
  Fig 2: Locating Bumper-To-Radiator Support Mounting Nuts
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.