Pinpoint Test U: DTC U0155:00
WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- U1 VERIFY THE CUSTOMER CONCERN
- Ignition ON.
- Verify there is an observable symptom present.
- Is an observable symptom present?
- Yes : GO to U2.
- No : The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
- U2 CHECK THE COMMUNICATION NETWORK
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
- Does the IPC pass the network test?
- Yes : GO to U3.
- No : REFER to MODULE COMMUNICATIONS NETWORK .
- U3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Check for recorded DTCs from the IPC self-test.
- Is DTC U3003:16 or DTC U3003:17 recorded?
- Yes : REFER to INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES .
- No : GO to U4.
- U4 RETRIEVE THE RECORDED DTCs FROM THE TCCM SELF-TEST
- Check for recorded DTCs from the TCCM self-test.
- Is DTC P0562:00 or DTC P0563:00 recorded?
- Yes : GO to PINPOINT TEST G .
- No : GO to U5.
- U5 RECHECK THE TCCM DTCs
- Clear the DTCs.
- Wait 10 seconds.
- Repeat the TCCM self-test.
- Is DTC U0155:00 still present?
- Yes : GO to U6.
- No : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
- U6 CHECK FOR DTC U0155:00 SET IN OTHER MODULES
- Clear all DTCs.
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Enter the following diagnostic mode on the scan tool: Self-Test.
- Retrieve the continuous memory DTCs from all modules.
- Is DTC U0155:00 set in the Body Control Module (BCM), Restraints Control Module (RCM), or Driver Door Module (DDM)?
- Yes : INSTALL a new IPC. REFER to INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES . TEST the system for normal operation.
- No : INSTALL a new TCCM. REFER to TRANSFER CASE CONTROL MODULE (TCCM) . TEST the system for normal operation. REPEAT the self-test.