Section 14 (Module Communications Network -- F250-F550 Super Duty)
WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Description And Operation
- Diagnosis And Testing
- Communications Network
- Notes
- Principles of Operation
- Notes
- High Speed Controller Area Network (HS-CAN) Modules
- Medium Speed Controller Area Network (MS-CAN) Modules
- Controller Area Network (CAN) Fault Tolerance
- Normal CAN Operation
- CAN Circuits Shorted Together
- CAN (+) Circuit Shorted To Ground
- CAN (-) Circuit Shorted To Ground
- CAN (+) Circuit Shorted To Battery Voltage
- CAN (-) Circuit Shorted To Battery Voltage
- CAN Circuit Signal Corruption
- Controller Area Network (CAN) Multiplex Messages
- Inspection and Verification
- DTC Charts
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A: The PCM Does Not Respond To The Scan Tool
- Pinpoint Test B: The ABS Module Does Not Respond To The Scan Tool
- Pinpoint Test C: The IPC Does Not Respond To The Scan Tool
- Pinpoint Test D: The Trailer Brake Control (TBC) Module Does Not Respond To The Scan Tool
- Pinpoint Test E: The Restraints Control Module (RCM) Does Not Respond To The Scan Tool
- Pinpoint Test F: The Auxiliary Heater Control Module (AHCM) Does Not Respond To The Scan Tool
- Pinpoint Test G: The Transmission Control Module (TCM) Does Not Respond To The Scan Tool
- Pinpoint Test H: The Body Control Module (BCM) Does Not Respond To The Scan Tool
- Pinpoint Test I: The Driver Seat Module (DSM) Does Not Communicate With the Scan Tool
- Pinpoint Test J: The HVAC Module Does Not Respond To The Scan Tool
- Pinpoint Test K: The Audio Control Module (ACM) Does Not Respond To The Scan Tool
- Pinpoint Test L: The Dual Climate Controlled Seat Module (DCSM) Does Not Respond To The Scan Tool
- Pinpoint Test M: The Satellite Digital Audio Receiver System (SDARS) Module Does Not Respond To The Scan Tool
- Pinpoint Test N: The Circuit Deactivation Ignition Module (CDIM) Does Not Communicate With the Scan Tool
- Pinpoint Test O: The Parking Aid Module (PAM) Does Not Respond To The Scan Tool
- Pinpoint Test P: The Global Positioning System Module (GPSM) Does Not Respond To The Scan Tool
- Pinpoint Test Q: The Transfer Case Control Module (TCCM) Does Not Respond To The Scan Tool
- Pinpoint Test R: The Accessory Protocol Interface Module (APIM) Does Not Respond To The Scan Tool
- Pinpoint Test S: The Steering Column Control Module (SCCM) Does Not Respond To The Scan Tool
- Pinpoint Test T: The Tire Pressure Monitor Module (TPM) Does Not Respond To The Scan Tool
- Pinpoint Test U: Intermittent No High Speed Controller Area Network (HS-CAN) Communication, One Or More Modules Are Not Responding During Network Test
- Pinpoint Test V: No High Speed Controller Area Network (HS-CAN) Communication, All Modules Are Not Responding
- Pinpoint Test W: Intermittent No Medium Speed Controller Area Network (MS-CAN) Communication, One Or More Modules Are Not Responding During Network Test
- Pinpoint Test X: No Medium Speed Controller Area Network (MS-CAN) Communication, All Modules Are Not Responding
- Pinpoint Test Y: No Power To The Scan Tool
- Communications Network