LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Windows And Glass - Glass, Frames And Mechanisms - F150) >> Diagnosis And Testing >> Glass, Frames and Mechanisms >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Window regulator and motor assembly
    • Window glass
    • Window control switch
    • Loose, corroded connectors
    • Circuitry
    • Window control switch
    • Battery Junction Box (BJB) fuse(s):
      • 32 (40A)
      • 54 (5A)
    • Body Control Module (BCM) circuit breaker 48 (30A)
    • BCM fuse(s):
      • 1 (30A)
      • 3 (30A)
      • 32 (15A)
    • Accessory delay relay
    • Rear window defrost relay
    • Rear window defrost grid
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
    4. NOTE: Make sure to use the latest scan tool software release.
  4. If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).
    5. NOTE: The Vehicle Communication Module (VCM) LED prove out confirms power and ground from the DLC are provided to the VCM.
  5. If the scan tool does not communicate with the VCM:
    • check the VCM connection to the vehicle.
    • check the scan tool connection to the VCM.
    • REFER to MODULE COMMUNICATIONS NETWORK , No Power To The Scan Tool, to diagnose no power to the scan tool.
  6. If the scan tool does not communicate with the vehicle:
    • verify the ignition is in the ON position.
    • verify the scan tool operation with a known good vehicle.
    • REFER to MODULE COMMUNICATIONS NETWORK , The PCM Does Not Respond To The Scan Tool, to diagnose no response from the PCM.
  7. Carry out the network test:
    • If the scan tool responds with no communication from one or more modules, REFER to MODULE COMMUNICATIONS NETWORK .
    • If the network test passes, retrieve and record the Continuous Memory Diagnostic Trouble Codes (CMDTCs).
  8. Clear the CMDTCs and carry out the self-test diagnostics for the BCM and HVAC module.
  9. If the DTCs retrieved are related to the concern, go to the Body Control Module (BCM) DTC Chart  or HVAC Module DTC Chart . For all other DTCs, REFER to MULTIFUNCTION ELECTRONIC MODULES .
  10. If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .
scientia non olet · About LEMON Manuals