LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 160 (Steering Column - F150) >> Diagnosis And Testing >> Steering Column >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
  3. Visually inspect for obstructions preventing column movement.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Steering column control switch
    • Adjustable steering column tilt motor
    • Adjustable steering column telescope motor
    • Steering column assembly
    • Wiring, terminals or connectors
    • Steering Column Control Module (SCCM)
  4. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
    5. NOTE: Make sure to use the latest scan tool software release.
  5. If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).
    6. NOTE: The Vehicle Communication Module (VCM) LED prove out confirms power and ground from the DLC are provided to the VCM.
  6. If the scan tool does not communicate with the VCM:
    • check the VCM connection to the vehicle.
    • check the scan tool connection to the VCM.
    • REFER to MODULE COMMUNICATIONS NETWORK , No Power To The Scan Tool, to diagnose no power to the scan tool.
  7. If the scan tool does not communicate with the vehicle:
    • verify the ignition is ON.
    • verify the scan tool operation with a known good vehicle.
    • REFER to MODULE COMMUNICATIONS NETWORK , The PCM Does Not Respond To The Scan Tool, to diagnose no response from the PCM.
  8. Carry out the network test.
    • If the scan tool responds with no communication for one or more modules, REFER to MODULE COMMUNICATIONS NETWORK .
    • If the network test passes, proceed with module self-test diagnostics.
  9. Carry out the self-test diagnostics for the SCCM.
  10. If the DTCs retrieved are related to the concern, go to Steering Column Control Module (SCCM) DTC Chart . For all other SCCM DTCs, refer to the Master DTC Chart in STEERING COLUMN SWITCHES .
  11. If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .
scientia non olet · About LEMON Manuals