LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (Starting System - F150) >> Diagnosis And Testing >> Starting System >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Always disconnect the battery ground cable at the battery before disconnecting the starter motor battery terminal lead. If a tool is shorted at the starter motor battery terminal, the tool can quickly heat enough to cause a skin burn. Failure to follow this instruction may result in serious personal injury.
NOTE: Make sure the anti-theft system is functioning correctly before carrying out a logical starting system diagnosis. Address anti-theft system concerns before continuing. REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
  1. Verify the customer concern.
  2. Remove the accessory drive belt. REFER to ACCESSORY DRIVE . Verify the crankshaft and each of the components driven by the accessory drive belt rotate and are not seized or damaged.
  3. Inspect to determine if any of the following mechanical or electrical concerns apply.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Starter motor
    • Starter motor bolts
    • Battery
    • Battery cables
    • Battery Junction Box (BJB) fuse 13 (30A)
    • Body Control Module (BCM) fuse 28 (15A)
    • Loose or corroded connections
    • Starter relay
  4. If an obvious cause for an observed or reported concern is found, correct the cause before proceeding to the next step.
    5. NOTE: Make sure to use the latest scan tool software release.
  5. If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).
    6. NOTE: The LED prove out confirms power and ground from the DLC are provided to the VCM.
  6. If the scan tool does not communicate with the VCM:
    • check the VCM connection to the vehicle.
    • check the scan tool connection to the VCM.
    • REFER to MODULE COMMUNICATIONS NETWORK , No Power To The Scan Tool, to diagnose no power to the scan tool.
  7. If the scan tool does not communicate with the vehicle:
    • verify the ignition key is in the ON position.
    • verify the scan tool operation with a known good vehicle.
    • REFER to MODULE COMMUNICATIONS NETWORK to diagnose no communication with the scan tool.
  8. Carry out the network test.
    • If the scan tool responds with no communication for one or more modules, REFER to MODULE COMMUNICATIONS NETWORK .
    • If the network test passes, proceed with module self-test diagnostics.
  9. Carry out the self-test diagnostics for the BCM, PCM and Tire Pressure Monitor Module (TPM) (TPM is standard equipment, also used for optional remote start feature).
  10. If the DTCs retrieved are related to the concern, go to DTC Charts .
  11. If no DTCs related to the concern are retrieved, GO to Symptom Chart .
scientia non olet · About LEMON Manuals