LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Automatic Transmission - 5R110W (TORQSHIFT(R)) -- F450 & F550 Super Duty) >> Specifications >> Clutch, Solenoid, Application Charts >> Application Chart (F)

Application Chart (F)

WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The Power Take-Off (PTO) may operate in any gear including PARK and NEUTRAL and does not require the overdrive One-Way Clutch (OWC). The torque converter may engage in PARK and NEUTRAL with PTO engaged.
CLUTCH, SOLENOID, APPLICATION CHART (F)

Selector Lever Position Gear Direct Clutch SSPCD Direct Clutch (I) Low Reverse Clutch SSPCE Low Reverse Clutch (D)
P P - LP/HA A (1)(2) (1)
N N - LP/HA A(1)(2) (1)
R R A (3) LP/HA(3) A(1) HP/HA(1)
(D) with Tow/Haul ON 1 - LP/HA A(1) (1)
(D) with Tow/Haul ON 2 - LP/HA A(1) HP/HA
(D) with Tow/Haul ON 3 - LP/HA - LP/LA
(D) with Tow/Haul ON 4 (4) - LP/HA - LP/LA
(D) with Tow/Haul ON 5 A HP/LA - LP/LA
(D) with Tow/Haul ON 6 A HP/LA - LP/LA
(1) PCM Calibration Controlled
(2) 207 kPa (30 psi) until speed reaches 5 km/h (3 mph)
(3) Clutch Applied Through Manual Valve Position
(4) Cold Strategy

HP = High Pressure
LP = Low Pressure
HA = High Current
LA = Low Current
A = Applied
(D) = Directly Proportional
(I) = Inversely Proportional