LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Automatic Transmission - 5R110W (TORQSHIFT(R)) -- F450 & F550 Super Duty) >> In-Vehicle Repair >> Transmission Support Insulator >> Removal

Transmission Support Insulator: Removal

WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position on a hoist. For additional information, refer to JACKING & LIFTING .
    2. NOTE: The transmission insulator studs may come out of the insulator while removing the insulator-to-crossmember nuts. Install new transmission insulator studs if the studs come out.
  2. Remove the transmission support crossmember. For additional information, refer to FULL FRAME AND BODY MOUNTING .
  3. Remove the transmission insulator from the extension housing.
    • Discard the bolts.
      Fig 1: Locating Transmission Insulator-To-Extension Housing Bolts
      G07482236Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals