Transmission Range (TR) Sensor: Removal

WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Disconnect the selector lever cable end.

Fig 1: Locating Selector Lever Cable End
Courtesy of FORD MOTOR CO.
Remove the transmission fluid pan, gasket and filter. For additional information, refer to FLUID PAN, GASKET AND FILTER .
Disconnect the Transmission Range (TR) sensor.

Fig 2: Locating Transmission Range Sensor
Courtesy of FORD MOTOR CO.

NOTE: The pin should be driven up through the manual valve.

Fig 3: Locating Manual Control Valve Detent Lever Shaft Retaining Pin

Courtesy of FORD MOTOR CO.

Remove and discard the manual control valve detent lever shaft retaining pin.
Using the Roll Pin Set, remove the manual control lever shaft retaining pin.

Fig 4: Removing Manual Control Lever Shaft Retaining Pin Using Roll Pin Set
Courtesy of FORD MOTOR CO.

NOTE: Be careful not to damage the manual control lever bore.

Fig 5: Locating Manual Control Lever Shaft Assembly

Courtesy of FORD MOTOR CO.

Remove the manual control lever shaft assembly.
Remove the TR sensor and detent lever assembly.
1. Remove the bolts.
2. Remove the TR sensor and detent lever assembly.
3. Disconnect the park rod from the detent lever assembly.
  
  Fig 6: Removing TR Sensor And Detent Lever Assembly
  Courtesy of FORD MOTOR CO.