LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Automatic Transmission - 5R110W (TORQSHIFT(R)) -- F450 & F550 Super Duty) >> In-Vehicle Repair >> Solenoid Body Assembly >> Installation

Solenoid Body Assembly: Installation

WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new solenoid body gasket.
    Fig 1: Locating Solenoid Body Gasket
    G06140626Courtesy of FORD MOTOR CO.
  2. Using the Valve Body Aligner, install the solenoid body and loosely install the bolts.
    • While installing the solenoid body, align the manual valve.
      Fig 2: Installing Solenoid Body And Bolts (Loosely)
      G06140628Courtesy of FORD MOTOR CO.
  3. Tighten all the bolts in the sequence shown in illustration.
    • Tighten to 13 Nm (115 lb-in).
      Fig 3: Solenoid Body Bolts Tightening Sequence
      G06599483Courtesy of FORD MOTOR CO.
  4. Connect the TR sensor connector.
    Fig 4: Locating TR Sensor Connector
    G06140630Courtesy of FORD MOTOR CO.
  5. Install the transmission fluid filter, pan gasket and pan. For additional information, refer to FLUID PAN, GASKET AND FILTER .
  6. Connect the transmission vehicle harness connector.
    • Tighten to 5 Nm (44 lb-in).
      Fig 5: Locating Transmission Vehicle Harness Connector
      G06140624Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals