LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Automatic Transmission - 5R110W (TORQSHIFT(R)) -- F450 & F550 Super Duty) >> In-Vehicle Repair >> Output Shaft Speed (OSS) Sensor >> Removal

Output Shaft Speed (OSS) Sensor: Removal

WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the Output Shaft Speed (OSS) sensor connector.
    Fig 1: Locating Output Shaft Speed (OSS) Sensor Connector
    G06140648Courtesy of FORD MOTOR CO.
    3. NOTE: Prior to removing the sensor, make sure that the area around the sensor is free of foreign material to prevent contamination entering the transmission.
  3. Remove the OSS sensor.
    1. Remove the bolt.
    2. Remove the OSS sensor.
Fig 2: Identifying OSS Sensor And Bolt
G06140649Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals