LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Automatic Transmission - 5R110W (TORQSHIFT(R)) -- F450 & F550 Super Duty) >> In-Vehicle Repair >> Output Shaft Speed (OSS) Sensor >> Installation

Output Shaft Speed (OSS) Sensor: Installation

WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the OSS sensor.
    1. Lubricate the O-ring with transmission fluid and install the OSS sensor.
    2. Install the bolt.
      • Tighten to 9 Nm (80 lb-in).
        Fig 1: Identifying OSS Sensor O-Ring And Bolt
        G06141130Courtesy of FORD MOTOR CO.
  2. Connect the OSS sensor connector.
    Fig 2: Locating Output Shaft Speed (OSS) Sensor Connector
    G06140648Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals