LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Automatic Transmission - 5R110W (TORQSHIFT(R)) -- F450 & F550 Super Duty) >> In-Vehicle Repair >> Internal Harness Service >> Installation

Internal Harness Service: Installation

WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Push the transmission internal harness connector through the transmission solenoid body, twist it to lock it in place.
  2. Connect the transmission internal harness.
    1. Install the 2 screws.
    2. Connect the TFT sensor.
    3. Connect the solenoid connectors.
      Fig 1: Identifying Transmission Fluid Temperature Sensor, Connector And Screws
      G06140695Courtesy of FORD MOTOR CO.
    3. NOTE: The O-ring seal must be installed in the top slot.
    Fig 2: Locating Transmission Internal Harness Connector O-Ring Seal
    G06140696Courtesy of FORD MOTOR CO.
  3. Install a new solenoid body transmission internal harness connector O-ring seal and lubricate it with automatic transmission fluid.
  4. Install the solenoid body assembly. For additional information, refer to SOLENOID BODY ASSEMBLY .
scientia non olet · About LEMON Manuals