Transmission Fluid Drain & Refill: Refill

WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Install the transmission fluid pan drain plug.
- Tighten to 18 Nm (159 lb-in).
  
  Fig 1: Locating Transmission Fluid Pan Drain Plug
  Courtesy of FORD MOTOR CO.

NOTE: The use of any transmission fluid other than specified may result in the transmission failing to operate in a normal manner or transmission failure.

Fill the transmission.
- Add 7.1L (7.5 qt) of transmission fluid to the transmission through the transmission fluid filler tube.
Start the engine. Move the selector lever through all the gear ranges, checking for engagements.
Using the scan tool with the engine running, check and make sure the transmission is at normal operating temperature 66-77°C (150-170°F). Check and adjust the transmission fluid level and check for any leaks. If transmission fluid is needed, add transmission fluid in increments of 0.24L (0.5 pt) until the correct level is achieved.