LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Automatic Transmission - 5R110W (TORQSHIFT(R)) -- F450 & F550 Super Duty) >> Diagnosis & Testing >> Pinpoint Tests - OSC Equipped Vehicle >> Solenoid Pre-Diagnosis

Solenoid Pre-Diagnosis

WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Use the following charts when carrying out the Pinpoint Tests.

NOTE: The PTO may operate in any gear including PARK and NEUTRAL and does not require the overdrive One-Way Clutch (OWC). The torque converter may engage in PARK or NEUTRAL with PTO engaged.
CLUTCH, SOLENOID, APPLICATION CHART (A)

Selector Lever Position Gear Engine Braking Line Pressure PCA (I) Forward Clutch Coast Clutch SSPCA Coast Clutch (I)
P P - HP/LA (1) - - LP/HA
N N - HP/LA(1) - - LP/HA
R R - HP/LA(1) - A HP/LA
(D) with Tow/Haul OFF 1 - HP/LA(1) A - LP/HA
(D) with Tow/Haul OFF 2 - HP/LA(1) A - LP/HA
(D) with Tow/Haul OFF 3 - HP/LA(1) A - LP/HA
(D) with Tow/Haul OFF 4 (2) Yes HP/LA(1) A - LP/HA
(D) with Tow/Haul OFF 5 - HP/LA(1) A - LP/HA
(D) with Tow/Haul OFF 6 Yes HP/LA(1) A - LP/HA
(1) PCM Calibration Controlled
(2) Cold Strategy

HP = High Pressure
LP = Low Pressure
HA = High Current
LA = Low Current
A = Applied
(I) = Inversely Proportional
NOTE: The PTO may operate in any gear including PARK and NEUTRAL and does not require the overdrive OWC. The torque converter may engage in PARK or NEUTRAL with PTO engaged.
CLUTCH, SOLENOID, APPLICATION CHART (B)

Selector Lever Position Gear OD Clutch SSPCB OD Clutch (D) Int. Clutch SSPCC Int. Clutch (D)
P P - LP/LA - LP/LA
N N - LP/LA - LP/LA
R R - LP/LA - LP/LA
(D) 1 - LP/LA - LP/LA
(D) 2 A HP/HA - LP/LA
(D) 3 - LP/LA A HP/HA
(D) 4 (1) A HP/HA A HP/HA
(D) 5 - LP/LA - LP/LA
(D) 6 A HP/HA - LP/LA
(1) Cold Strategy

HP = High Pressure
LP = Low Pressure
HA = High Current
LA = Low Current
A = Applied
(D) = Directly Proportional
NOTE: The PTO may operate in any gear including PARK and NEUTRAL and does not require the overdrive OWC. The torque converter may engage in PARK or NEUTRAL with PTO engaged.
CLUTCH, SOLENOID, APPLICATION CHART (C)

Selector Lever Position Gear Direct Clutch SSPCD Direct Clutch (I) Low Reverse Clutch SSPCE Low Reverse Clutch (D)
P P - LP/HA A (1)(2) (1)
N N - LP/HA A(1)(2) (1)
R R A (3) LP/HA(3) A(1) HP/HA(1)
(D) with Tow/Haul OFF 1 - LP/HA A(1)(4) (1)
(D) with Tow/Haul OFF 2 - LP/HA - LP/LA
(D) with Tow/Haul OFF 3 - LP/HA - LP/LA
(D) with Tow/Haul OFF 4(3) - LP/HA - LP/LA
(D) with Tow/Haul OFF 5 A HP/LA - LP/LA
(D) with Tow/Haul OFF 6 A HP/LA - LP/LA
(1) PCM Calibration Controlled
(2) 207 kPa (30 psi) until mph reaches 5 km/h (3 mph)
(3) Clutch Applied Through Manual Valve Position
(4) Cold Strategy

HP = High Pressure
LP = Low Pressure
HA = High Current
LA = Low Current
A = Applied
(D) = Directly Proportional
(I) = Inversely Proportional
NOTE: The PTO may operate in any gear including PARK and NEUTRAL and does not require the overdrive OWC. The torque converter may engage in PARK or NEUTRAL with PTO engaged.
CLUTCH, SOLENOID, APPLICATION CHART (D)

Selector Lever Position Gear TCC Torque Converter (D) OD OWC L/R OWC
P P LP/LA X X
N N LP/LA X X
R R LP/LA X -
(D) 1 (1) X X
(D) 2 (1) O/R X
(D) 3 (1) X O/R
(D) 4 (2) (1) O/R O/R
(D) 5 (1) X O/R
(D) 6 (1) O/R O/R
(1) PCM Calibration Controlled
(2) Cold Strategy

O/R = Overrunning
LP = Low Pressure
LA = Low Current
X = Holding
(D) = Directly Proportional
NOTE: The PTO may operate in any gear including PARK and NEUTRAL and does not require the O/DOWC. The TCC may engage in PARK and NEUTRAL with PTO engaged.
CLUTCH, SOLENOID, APPLICATION CHART (E)

Selector Lever Position Gear Engine Braking Line Pressure PCA (I) Forward Clutch Coast Clutch SSPCA Coast Clutch (I)
P P - HP/LA(1) - - LP/HA
N N - HP/LA(1) - - LP/HA
R R - HP/LA(1) - A HP/LA
(D) with Tow/Haul ON 1 Yes HP/LA(1) A A HP/LA
(D) with Tow/Haul ON 2 Yes HP/LA(1) A - LP/HA
(D) with Tow/Haul ON 3 Yes HP/LA(1) A A HP/LA
(D) with Tow/Haul ON 4 (2) Yes HP/LA(1) A - LP/HA
(D) with Tow/Haul ON 5 Yes HP/LA(1) A A HP/LA
(D) with Tow/Haul ON 6 Yes HP/LA(1) A - LP/HA
(1) PCM Calibration Controlled
(2) Cold Strategy

HP = High Pressure
LP = Low Pressure
HA = High Current
LA = Low Current
A = Applied
(I) = Inversely Proportional
NOTE: The PTO may operate in any gear including PARK and NEUTRAL and does not require the overdrive OWC. The torque converter may engage in PARK or NEUTRAL with PTO engaged.
CLUTCH, SOLENOID, APPLICATION CHART (F)

Selector Lever Position Gear Direct Clutch SSPCD Direct Clutch (I) Low Reverse Clutch SSPCE Low Reverse Clutch (D)
P P - LP/HA A (1)(2) (1)
N N - LP/HA A(1)(2) (1)
R R A (3) LP/HA(3) A(1) HP/HA(1)
(D) with Tow/Haul ON 1 - LP/HA A(1) (1)
(D) with Tow/Haul ON 2 - LP/HA A(1) HP/HA
(D) with Tow/Haul ON 3 - LP/HA - LP/LA
(D) with Tow/Haul ON 4 (4) - LP/HA - LP/LA
(D) with Tow/Haul ON 5 A HP/LA - LP/LA
(D) with Tow/Haul ON 6 A HP/LA - LP/LA
(1) PCM Calibration Controlled
(2) 207 kPa (30 psi) until mph reaches 5 km/h (3 mph)
(3) Clutch Applied Through Manual Valve Position
(4) Cold Strategy

HP = High Pressure
LP = Low Pressure
HA = High Current
LA = Low Current
A = Applied
(D) = Directly Proportional
(I) = Inversely Proportional
NOTE: The PTO may operate in any gear including PARK and NEUTRAL and does not require the overdrive OWC. The torque converter may engage in PARK or NEUTRAL with PTO engaged.
CLUTCH, SOLENOID, APPLICATION CHART (G)

Selector Lever Position Gear Engine Braking Line Pressure PCA (I) Forward Clutch Coast Clutch SSPCA Coast Clutch (I)
Manual 3rd 3 Yes HP/LA (1) A A HP/LA
Manual 2nd 2 Yes HP/LA(1) A - LP/HA
Manual 1st 1 Yes HP/LA(1) A A HP/LA
(1) PCM Calibration Controlled

HP = High Pressure
LA = Low Current
LP = Low Pressure
HA = High Current
A = Applied
(I) = Inversely Proportional
NOTE: The PTO may operate in any gear including PARK and NEUTRAL and does not require the overdrive OWC. The torque converter may engage in PARK or NEUTRAL with PTO engaged.
CLUTCH, SOLENOID, APPLICATION CHART (H)

Selector Lever Position Gear OD Clutch SSPCB OD Clutch (D) Int. Clutch SSPCC Int. Clutch (D)
Manual 3rd 3 - LP/LA A HP/HA
Manual 2nd 2 A HP/HA - LP/LA
Manual 1st 1 - LP/LA - LP/LA
HP = High Pressure
LP = Low Pressure
HA = High Current
LA = Low Current
A = Applied
(I) = Inversely Proportional
NOTE: The PTO may operate in any gear including PARK and NEUTRAL and does not require the overdrive OWC. The torque converter may engage in PARK or NEUTRAL with PTO engaged.
CLUTCH, SOLENOID, APPLICATION CHART (I)

Selector Lever Position Gear Direct Clutch SSPCD Direct Clutch (I) Low Reverse Clutch SSPCE Low Reverse Clutch (D)
Manual 3rd 3 - LP/HA - LP/LA
Manual 2nd 2 - LP/HA A HP/HA
Manual 1st 1 - LP/HA A HP/HA
HP = High Pressure
LP = Low Pressure
HA = High Current
LA = Low Current
A = Applied
(D) = Directly Proportional
(I) = Inversely Proportional
NOTE: The PTO may operate in any gear including PARK and NEUTRAL and does not require the overdrive OWC. The torque converter may engage in PARK or NEUTRAL with PTO engaged.
CLUTCH, SOLENOID, APPLICATION CHART (J)

Selector Lever Position Gear TCC Torque Converter (D)
Manual 3rd 3 (1)
Manual 2nd 2 (1)
Manual 1st 1 (1)
(1) PCM Calibration Controlled

O/R = Overrunning
X = Holding
(D) = Directly Proportional
scientia non olet · About LEMON Manuals