Pinpoint Tests - OSC Equipped Vehicle: Notes
WARNING: This page is about a different car, the 2012 Ford F550 Super Duty and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOLS CHART
| Fluke 77-IV Digital Multimeter FLU77-4 or equivalent |
|
| Transmission Fluid Pressure Gauge 307-004 (T57L-77820-A) |
|
| Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool |
NOTE:
If equipped, turn the Power Take-Off (PTO) unit off for correct test results. For a description of PTO operation, refer to TRANSMISSION ELECTRONIC CONTROL SYSTEM . The PCM self-test test is not accessible when the PTO unit is in operation. Shift Solenoid Pressure Control B (SSPCB) is on when the PTO is in operation.
When an electrical connector or solenoid body is disconnected, inspect the connector for terminal condition, corrosion and contamination. Also inspect the connector seal for damage. Clean, repair or install a new connector as required.