LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Focus S, Standard Trans, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Dual Clutch Transaxle (DCT) POWERSHIFT (DPS6/6DCT250)) >> Removal and Installation >> Input Shaft Seal >> Removal

Input Shaft Seal: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Refer to: Transmission - 2.0L Duratec-HE  .

    Refer to: Clutch Unit  .

  2. Special Tool(s)  : 307-673 (Remover, Outer Input Shaft Seal) 
    Fig 1: Removing Outer Input Shaft Seal Using Special Tools
    G07979754Courtesy of FORD MOTOR CO.
  3. Refer to: Clutch Actuator  .
  4. Fig 2: Locating Input Shaft Seal Housing Surface Mounting Bolts
    G08064107Courtesy of FORD MOTOR CO.
    5. NOTE: Take extra care not to damage the bearing.
    Fig 3: Removing Input Shaft Seal Using Special Tools
    G07979765Courtesy of FORD MOTOR CO.
  5. Special Tool(s)  : 100-001 (Slide Hammer)  , 308-375 (Remover, Input Shaft Seal) 
  6. Fig 4: Cleaning Input Shaft Seal
    G08064109Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals