LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Focus S, Standard Trans, Gas >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation, Message Center, And Warning Chimes - Except Electric >> Diagnosis and Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> U0140:00 >> Pinpoint Test AF: U0140:00

Pinpoint Test AF: U0140:00

  1. AF1 VERIFY THE CUSTOMER CONCERN 
    • Ignition ON.
    • Verify there is an observable symptom present.

    Is an observable symptom present? 

    1. Yes:  GO to AF2
    2. No:  The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  2. AF2 CHECK THE COMMUNICATION NETWORK 
    • Ignition ON.
    • Using a scan tool, perform a Network Test.

    Does the BCM pass the network test? 

    1. Yes:  GO to AF3
    2. No:  REFER to: COMMUNICATIONS NETWORK .
  3. AF3 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE BCM (BODY CONTROL MODULE) SELF-TEST 
    • Using a scan tool, perform the BCM module self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    1. Yes:  REFER to: BODY CONTROL MODULE (BCM) .
    2. No:  GO to AF4
  4. AF4 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST 
    • Using a scan tool, perform the IPC self-test.

    Is DTC U3006:16 or DTC U3006:17 recorded? 

    1. Yes:  For DTC U3006:16, GO to Pinpoint Test AM 

      For DTC U3006:17, GO to Pinpoint Test AN 

    2. No:  GO to AF5
  5. AF5 RECHECK THE IPC (INSTRUMENT PANEL CLUSTER) DIAGNOSTIC TROUBLE CODES (DTCS) 
    NOTE: If new modules were installed prior to the DTC being set, the module configuration can be incorrectly set during the Programmable Module Installation (PMI) or the Programmable Module Installation (PMI) may not have been carried out.
    • Clear the Diagnostic Trouble Codes (DTCs).
    • Wait 10 seconds.
    • Using a scan tool, perform the IPC self-test.

    Is DTC U0140:00 still present? 

    1. Yes:  INSTALL a new BCM.

      REFER to: BODY CONTROL MODULE (BCM) .

      CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test. If DTC U0140 is still present, INSTALL a new IPC.

      REFER to: Instrument Panel Cluster (IPC)  .

    2. No:  The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
scientia non olet · About LEMON Manuals