LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Focus S, Standard Trans, Gas >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation, Message Center, And Warning Chimes - Except Electric >> Diagnosis and Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> U3006:17 >> Pinpoint Test An: U3006:17

Pinpoint Test An: U3006:17

  1. AN1 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) B1317, B1676, P0563 (PCM (POWERTRAIN CONTROL MODULE)) OR U3003:17 SET IN OTHER MODULES 
    • Ignition ON.
    • Using a scan tool, perform the self-test.
    • Retrieve the continuous memory Diagnostic Trouble Codes (DTCs) from all modules.

    Is DTC B1317, B1676, P0563 (PCM or U3003:17 set in more than one module? 

    1. Yes:  REFER to: CHARGING SYSTEM - 2.0L DURATEC-HE .
    2. No:  GO to AN2
  2. AN2 CHECK THE BATTERY VOLTAGE 
    • Turn off all interior/exterior lights and accessories.
    • Start and run the engine at approximately 2, 000 rpm for 3 minutes while monitoring the battery voltage.

    Does the battery voltage rise to 15.5 volts or higher? 

    1. Yes:  REFER to: CHARGING SYSTEM - 2.0L DURATEC-HE .
    2. No:  GO to AN3
  3. AN3 RECHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U3006:17 
    • Turn the engine off.
    • Ignition ON.
    • Using a scan tool, clear the continuous memory Diagnostic Trouble Codes (DTCs).
    • Carry out the IPC self-test.

    Is DTC U3006:17 present? 

    1. Yes:  INSTALL a new IPC.

      REFER to: Instrument Panel Cluster (IPC)  .

    2. No:  The system is operating normally at this time. The DTC may have been set previously during battery charging or while jump starting the vehicle.
scientia non olet · About LEMON Manuals