Pinpoint Test BC: The Key Left In Vehicle Or Passive Key Out Of Vehicle Chime Is Inoperative - With Intelligent Access (IA)

BC1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.
Does the safety belt warning chime operate for approximately 6 seconds?
1. Yes: GO to BC2
2. No: GO to Pinpoint Test BJ
BC2 CHECK THE SMART UNLOCK FUNCTION
- Verify that the smart unlock function operates correctly.
  REFER to: HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS - SYSTEM OPERATION AND COMPONENT DESCRIPTION .
  
  REFER to: HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS - SYSTEM OPERATION AND COMPONENT DESCRIPTION .
Does the smart unlock function operate correctly?
1. Yes: GO to BC3
2. No:
BC3 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a scan tool, perform the IPC self-test.
Is DTC U0140:00 recorded?
1. Yes: GO to Pinpoint Test AF
2. No: GO to BC4
BC4 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE BCM (BODY CONTROL MODULE) SELF-TEST
- Using a scan tool, perform a BCM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
1. Yes: REFER to: BODY CONTROL MODULE (BCM) .
2. No: INSTALL a new BCM.
  REFER to: BODY CONTROL MODULE (BCM) .