Pinpoint Test A : The Rear Video Is Inoperative: Notes
WARNING: This page is about a different car, the 2015 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
Refer to PARKING AID for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description .
BCM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B12BD:49 | Rear Camera: Internal Electrical Failure | A continuous memory DTC that sets in the BCM when an internal fault in the rear parking aid camera is detected. |
APIM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| C1001:01 | Vision System Camera: General Electrical Failure | A continuous memory and on-demand DTC that sets in the APIM if no video signal is detected from the rear parking aid camera when the vehicle is in REVERSE. |
Possible Causes
- Wiring, terminals or connectors
- Dirty rear parking aid camera lens
- Fuse
- Communication network concern
- Rear parking aid camera configuration
- Rear parking aid camera
- Reversing lamp concern
- LIN concern
- IPC concern
- APIM concern
- FDIM concern
- BCM
Visual Inspection and Diagnostic Pre-Checks
- RJB Fuse 29 (5A).
- Verify the luggage compartment lid is fully closed.
- If the rear parking aid camera is not configured after replacement, some video functions will be inoperative. Verify the rear parking aid camera configuration using the diagnostic scan tool.
NOTE:
Before disconnecting the rear parking aid camera, verify the connector is properly seated and latched.