Pinpoint Test C: The Speedometer Is Inoperative
- C1 PERFORM THE INSTRUMENT PANEL CLUSTER (IPC) SELF-TEST
- Ignition ON.
- Using a scan tool, perform the IPC self-test.
- Check for recorded Diagnostic Trouble Codes (DTCs) from the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
- Yes : REFER to DTC CHART: IPC .
- No : GO to C2
- C2 PERFORM THE BODY CONTROL MODULE (BCM) SELF-TEST
- Using a scan tool, perform the BCM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
- Yes : REFER to: BODY CONTROL MODULE (BCM) .
- No : GO to C3
- C3 PERFORM THE GATEWAY MODULE (GWM) SELF-TEST
- Using a scan tool, perform the GWM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
- Yes : REFER to: COMMUNICATIONS NETWORK .
- No : GO to C4
- C4 PERFORM THE SPEEDOMETER ACTIVE COMMAND USING A SCAN TOOL
- Enter the following diagnostic mode on the scan tool: IPC DataLogger.
- Select the IPC speedometer (SPDOMETER) Parameter Identification (PID).
- Command the speedometer on and off while monitoring the speedometer.
Does the speed begin at 0 km/h (0 mph) move to 193 km/h (120 mph) and return to 0 km/h (0 mph)?
- Yes
: DIAGNOSE all ABS
module Diagnostic Trouble Codes (DTCs).
REFER to: ANTI-LOCK BRAKE SYSTEM (ABS) AND STABILITY CONTROL .
- No
: INSTALL a new IPC
.
REFER to: Instrument Panel Cluster (IPC) .