LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Limited, 3.5 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Ignition Lock Cylinder - Functional >> Removal

Ignition Lock Cylinder - Functional: Removal

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Passive Anti-Theft System (PATS) transceiver. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
  2. Remove the ignition lock cylinder in the following sequence:
    1. Insert the ignition key and position the ignition lock cylinder to the ACC position.
    2. Using a suitable tool, depress the ignition lock cylinder release pin through the access hole while pulling the ignition lock cylinder outward.
      Fig 1: Locating Locking Pin
      G06173861Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals