LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Fuel Charging System & Fuel Control System - Turbocharger) >> Diagnosis And Testing >> Turbocharger >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This article provides mechanical diagnosis of the turbocharger assembly. If there is a Malfunction Indicator Lamp (MIL) illuminated, or DTCs are present, these should be diagnosed prior to performing turbocharger mechanical diagnosis. Refer to the INTRODUCTION - DIESEL MODELS .
  1. Verify the customer concern.
  2. Inspect the entire turbocharger system for obvious signs of damage or other mechanical concerns, using the following chart.
    VISUAL INSPECTION CHART

    Mechanical
    • Damaged turbocharger
      • Foreign object damage
      • Turbo spins freely
    • Damaged intake hoses
    • Loose hose clamps
    • Loose or broken Charge Air Cooler (CAC) tube clip
    • Missing or damaged CAC tube O-ring
    • Damaged CAC
    • Restricted intake or exhaust
    • Damaged/plugged or disconnected Manifold Absolute Pressure (MAP) sensor
    • Exhaust leaks
    • Air leaks
    • Inspect oil (dirty, incorrect level or diluted)
    • Oil leaks
    • Coolant leaks
  3. If the concern(s) remains after the inspection, GO to SYMPTOM CHART .
  4. If a driveability condition still exists, refer to the INTRODUCTION - DIESEL MODELS .